I have also seen this pin called Select, DTR and Command. ![]() This signal will go low for the duration of a transmission. ATTĪTT is used to get the attention of the controller. The main board in the PSX also has a surface mount 750mA fuse that will blow if you try to draw to much current through the plug (750mA is for both left, right and memory cards). ![]() The controllers outlined here really want 5V. VCC can vary from 5V down to 3V and the official SONY Controllers will still operate. It is again an 8 bit serial transmission on the falling edge of clock. All the reading of signals is done on the leading edge to allow settling time.) COMMAND ![]() ![]() This signal is an 8 bit serial transmission synchronous to the falling edge of clock (That is both the incoming and outgoing signals change on a high to low transition of clock. 9 pin Sony Playstation special connector at the deivce, looking at the plug
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |